Throttle body removal and installation.
Throttle body cable install.
The final step is to adjust the throttle valve cable.
In fact most can be installed in less than 30 minutes with basic hand tools.
Yes from our first mustang 5 0l throttle body in 1988 to our latest auto truck units each bbk power plus series throttle body is designed as a simple do it yourself bolt on.
Loosen and remove the two screws securing the throttle cable and cruise control cable to the bracket.
The other end is on the driver s side floor attached to the accelerator pedal.
They are designed with a specially extruded liner for extended life of the cable not to be confused with ordinary braided brake hose.
Locate the throttle cable.
1 2 and 3 for the component names.
The cable must be adjusted so it is pulled fully out at wide open throttle.
Removing throttle cable from saturn s series throttle body.
Remove the throttle cable.
Can i install my own bbk throttle body.
One end of the throttle cable is located in the engine compartment attached to the throttle body.
Part 2 of 3.
This throttle cable is designed to be cut to fit for your particular application.
The gm tuned port injection tpi kit includes two throttle body fittings.
The brass throttle body fitting with.
This is usually done by either.
Disconnect the throttle cable at the throttle body.
8mm socket throttle cable assembly 10mm socket negative battery cable 13mm socket tb hold down bolts 25 torx driver tb sensors 3 16 allen wrench new tb hold down bolts 1 remove the throttle body hat.
Loosen and remove the two 10mm bolts securing the bracket to the intake manifold then remove the cruise control and throttle cable from the bracket.
Install the opposite ends of the throttle cables to the carburetor or throttle body tightening the threaded ends of the cable guides into the cable bracket completely.
I also show how t.
Throttle cables all lokar throttle cables are available in either stainless steel braided housing black stainless steel braided housing or black housing.
Dislodge the throttle cable from the ball stud on the throttle body.
In this video i show how to remove your old stock throttle and idle cables and install some beautiful braided lines from magnum shielding.
Slide the cables barrels into the valve catches and twist the throttle tube slightly to check that the valves open and close properly.
This video is not meant to be a definitive how to always consult a professional repai.
